Mounting Accessories
High-strength, UV-resistant black polymer construction
850 and 851 series lights snap in with no grommet required
Mounts with four screws
Surface mount bracket, horizontal and vertical variants
High-strength, UV-resistant black polymer construction
850 and 851 series lights snap in with no grommet required
Separate backing plate with two 25 mm cable exit hole, integral mounting studs, plus attachment screws
Two-piece construction for easy installation and maintenance
Surface mount bracket, horizontal and vertical variants
High-strength, UV-resistant black polymer construction
850 and 851 series lights snap in with no grommet required
Separate backing plate with two 25 mm cable exit hole, integral mounting studs, plus attachment screws
Two-piece construction for easy installation and maintenance
Lights not included
Electrical Accessories
Dual voltage 12/24 V – 10A maximum load
Mounts with four screws
Pre-programmed for 30 min. of ON time per button push
Up to four 30-minute increments may be entered, for a total unattended illumination time of 2 hours
Additional time (up to the 2 hour max) may be added at any time
Lights flash briefly with each button push to indicate that command is received
Pushing and holding button turns off lights at any time
“2 minute warning” slowly dims and raises light level prior to shut-off
Available in surface mount and recessed mount versions
For 24 Vdc systems
The 5505 unit enables the vehicle bulb monitoring system to:
Recognise the low current draw of an operating LED direction indicator light
Recognise any failure of the indicator light by providing in-cab bulb failure warning
Rubber injection-moulded construction with silicon seal
225 mm leads
Includes stripped hot wire
Ground wire terminated with #10 ring terminal and heat shrink tubing for additional corrosion protection
Fits 162, 163, 164, 165 and 166 series LED clearance / marker lights
Hard plastic housing and separate silicone seals
225 mm leads
Ground wire terminated with #10 ring terminal and heat-shrink tubing
Fits 1216, 1217, 1218, 1220, 1222 & 1223 LumenX® lights & all other lights with AMP compatible receptacles
Grease is not recommended on AMP-style connections
Harness Kits
Developed for the agricultural, car, boat, and general trailer market
Harnesses designed and manufactured to customer requirements
4 standard length trailer kits available
Supplied with lights to customer specification, selected from the PM range of multi-function, combination, and single-function rear lights, and front, side and rear marker lights
Dual voltage 12/24V
Harness fitted with 7-way 12N trailer plug
Developed for the agricultural, car, boat, and general trailer market
Harnesses designed and manufactured to customer requirements
4 standard length trailer kits available
Supplied with lights to customer specification, selected from the PM range of multi-function, combination, and single-function rear lights, and front, side and rear marker lights
Dual voltage 12/24V
Harness fitted with 7-way 12N trailer plug
Equipped with side marker and number plate light harness spurs
Surface mount bracket, single, twin and triple variants
High-strength, UV-resistant black polymer construction
817 & 1217 series lights snap in with no grommet required
Brackets feature separate backing plate with 25 mm cable exit hole and integral mounting studs, plus attachment screws
Lights not included
More info >